Dome Light Assembly Replacement.

Larry

New Member
Jan 21, 2021
3
0
1
Georgia
Hey y'all I have an 01 Toyota Sequoia Limited W/ sunroof and no rear entertainment system. I'm looking around to see if anyone has any information regarding the correct dome light that's supposed to fit in the center roof area. Every Dome light I find on Ebay has a 4 pin connector that plugs into the factory harness yet my Toyota only has has a 3 pin harness in the location. Any help would be appreciated Thanks.20210121_084008.jpg20210121_083941.jpg20210121_083931.jpg
 
Last edited:

Larry

New Member
Jan 21, 2021
3
0
1
Georgia
That one looks like the one that would be close to the hatch/trunk area. The cut out in the headliner looks like the half moon shape dome lights that some of the models came with. The parts department at my local Toyota gave me Part number 81240-0C030-E0. Only problem being that there would be no way to use that light seeing it uses a 4 pin harness instead of a three pin. This is what the shape of the dome light should look based on what Toyota has in their diagrams.s-l1600.jpg20210122_100246.jpg
 
Last edited:

Jgrauman

Active Member
Feb 18, 2019
185
39
28
39
I have installed the one you just pictured above in my Sequoia when I took out the DVD player. It's 4 wires, but you can just cut off that plug and put female spade connectors to attach to the light. The outside lights are switched independently always hot, the main is switched always hot and door switch. Easy enough to figure out with a multimeter
 
  • Like
Reactions: Larry

Larry

New Member
Jan 21, 2021
3
0
1
Georgia
Seems like what im going to end up having to do. In that case, im going to see about ordering the assembly and making it work. Did you do anything about the fourth pin in the factory domelight or did you just connect 3 spades and leave one open?
 
Last edited:

Jgrauman

Active Member
Feb 18, 2019
185
39
28
39
I honestly don't remember. I removed a DVD entertainment system so the wiring was hacked up already.