I posted this on ih8mud but I’m hoping this forum is alive and well now.
I’ve been researching the sequoia builds on about every forum I can find since my father in law gave us his sequoia. It’s a 2002 Limited with 196k miles in the clock.
Since I’ve owned it I’ve replaced the following:
-brake rotors/pads
-stereo
-rear bumper
-front passenger fender
-plugs, coils, and o2 sensors (o2 sensors were cheap Chinese, replacing again with Denso)
-replaced both front seat leathers
-replaced rear hatch handle and window motor
-replaced driver window regulator
Parts in the garage:
OME 2.5” lift from 1st Gen offroad
Freedom Offroad UCAs from 1st gen Offroad
Maxi Trac awning from Napa
Pro comp street lock 16x8” black steel wheels.
Yaw rate sensor
OEM lower Ball Joint
Still to come
-Tires thinking ko2s
-JBA shorty headers (needed for tick and stuck o2 sensor)
-wheel bearings
-Sherpa rack
-ARB tundra bumper
-xbull winch
-either coastal Offroad bumper or rigd tire carrier
-100 series snorkel
I’ve been researching the sequoia builds on about every forum I can find since my father in law gave us his sequoia. It’s a 2002 Limited with 196k miles in the clock.
Since I’ve owned it I’ve replaced the following:
-brake rotors/pads
-stereo
-rear bumper
-front passenger fender
-plugs, coils, and o2 sensors (o2 sensors were cheap Chinese, replacing again with Denso)
-replaced both front seat leathers
-replaced rear hatch handle and window motor
-replaced driver window regulator
Parts in the garage:
OME 2.5” lift from 1st Gen offroad
Freedom Offroad UCAs from 1st gen Offroad
Maxi Trac awning from Napa
Pro comp street lock 16x8” black steel wheels.
Yaw rate sensor
OEM lower Ball Joint
Still to come
-Tires thinking ko2s
-JBA shorty headers (needed for tick and stuck o2 sensor)
-wheel bearings
-Sherpa rack
-ARB tundra bumper
-xbull winch
-either coastal Offroad bumper or rigd tire carrier
-100 series snorkel